EV Charger Installation
Level 2 charging installed only after a load check confirms the panel can carry it, or a plan for when it cannot.
What this involves
Yarrow Point, Washington
Yarrow Point Electricians for Waterfront Homes
Panel upgrades, EV chargers, lighting and rewiring, plus long runs to detached garages and outbuildings, all quoted in writing once we have seen the house.
Have us out to look — (000) 000-0000A look before any price
We see the job in person first, so the figure you get reflects your house rather than a guess.
Written scope, no surprises
The estimate lists what is included, so any change is agreed with you before it is added.
Permits handled by us
Panel, charger and remodel work is inspected work; we file for it and meet the inspector.
What we do
Electrical services for the whole house
Each service has a page that walks through the work and how we schedule it around you.
Electrical Remodels & Renovation Wiring
Electrical for kitchens, baths and additions, laid out from your plans and timed to each inspection.
What this involves
Whole-Home Rewiring
Old cable and ungrounded circuits replaced over planned stages, with openings kept small and patched neatly.
What this involves
Dedicated Circuit Installation
A dedicated line for the appliance or tool that keeps tripping whatever circuit it shares today.
What this involves
Emergency Electrical Service
Burning smells, scorched outlets, dead circuits and failed mains moved up our schedule during working hours.
What this involves
Electrical Panel Upgrades
Panel and service upgrades sized from a proper load calculation, with the utility and permit steps managed for you.
What this involves
New Construction Wiring
Electrical for new homes and large additions, from service entrance to trim, priced from the drawings and built to schedule.
What this involves
Lighting Installation & Upgrades
Interior layers, exterior and path lighting, and dimmers matched to your fixtures so nothing flickers or hums.
What this involves
Electrical Troubleshooting & Repair
Intermittent faults, tripping breakers and dead outlets tracked to their source, then repaired properly once.
What this involves
Why us
Why choose us
Clear options, clean work and paperwork that is finished properly.
- Options before a price — we look at the job, lay out the choices and what each involves, then put a figure on the one you pick
- Honest about what you need — if your current panel or wiring can handle the job, we tell you, even when it means a smaller invoice
- Labelled, readable panels — each breaker we work on gets a clear name on the panel schedule, which saves time on any later repair
- Inspections seen through — we file the permit, attend the inspection and hand over the approval
Where we work
Service across Yarrow Point and nearby
- Yarrow Point
- Hunts Point
- Clyde Hill
- Medina
- Kirkland
- Bellevue
- Houghton
- Mercer Island
Free in-home estimates across Yarrow Point and the neighbouring Points, with long runs to garages and outbuildings measured before we price. The full list is on the service areas page.
Questions
Questions homeowners ask us
Why would a breaker trip when nothing unusual is running?
A breaker that trips without an obvious overload usually points to a fault on the circuit, such as a damaged cable, a failing device or a loose termination that is heating up, or to a breaker that has weakened with age. We test the circuit at the visit, show you what we found and quote the repair it needs, nothing more.
When is a 200-amp service actually worth it?
When the house is asking more of its service than it can give. Electric heating, a car charger, a larger kitchen or an addition all add load, and a load calculation shows whether your current service can absorb them. If it can, we say so; if not, the upgrade is priced in writing with the utility work included.
Is an old Federal Pacific or Zinsco panel a real risk?
It is a known weak point. Breakers in those panels have a history of not tripping when they should, so the wiring they protect can overheat. If you find either name on the label, have it checked; we look at its condition during the in-home estimate and give you a written replacement price.
How long is your workmanship covered?
Two years from completion, on the labor for what we install. That includes connections on our devices working loose, terminations not done correctly, outlets, switches or plates left poorly secured, and circuit interruptions traced to how we connected something. In those cases we return, check it and correct it with no additional labor charge. Manufacturer defects, wear and tear, misuse, alterations or work by others, and hidden faults in pre-existing wiring sit outside that cover, and product warranties from the manufacturer apply separately.
How long will a panel changeover keep my power off?
Expect the house to be without power for a good part of one working day while the new panel is fitted and connected. The utility has to cut and restore the service, and the permit must be approved first, so we book the date around both and tell you well ahead.
What does the in-home estimate cost?
Nothing. We come to the house, look at the panel and the job, explain your options and leave a written figure. You decide in your own time, with no obligation to go ahead.
Can I charge an EV at home with my current panel?
Often, yes. A Level 2 charger needs a dedicated circuit and enough spare capacity in the service to run alongside everything else. We check both at the estimate; where capacity is short, a lower-amperage charger or load management can often avoid an upgrade.
Get a written price after a free in-home look
Describe the job, whether it is a panel, a charger, lighting or a fault. We will come out, explain your options and leave a written figure.
Book a free in-home estimate — (000) 000-0000